ALLIANCE HA050L User Manual download pdf (Page 10)

70381601

Display Identification

Light Emitting Diodes (LEDs)

Light Emitting Diodes (LEDs) are used to indicate the

chosen cycle status. Refer to LED descriptions below.

START LED

The START keypad LED flashes whenever the tumble

dryer is not in a cycle, the full vend price has been

satisfied, and the tumble dryer door is closed. When

the START keypad is pressed, the cycle will begin or

resume. The START LED will shut off when the

START keypad is pressed. The START LED will also

flash any time a card is inserted to add time to the

current cycle.

DRYING LED

The DRYING LED is lit to indicate that a heated

portion of a cycle is currently in operation. The

DRYING LED goes off when the COOL DOWN

cycle begins.

COOL DOWN LED

The COOL DOWN LED is lit whenever the COOL

DOWN portion of a cycle or a no heat cycle is active.

The COOL DOWN LED will shut off when a cycle

ends or if enough time is added to push the cycle back

into the heated portion of a cycle.

FOUR 7-SEGMENT DIGITS

The 7-SEGMENT DIGITS are used to display the

time remaining in a cycle, vend price, error messages

and descriptive codes. When displaying the time

remaining, the time value is displayed on the right side

of the display. When displaying the vend price, the

value is displayed on the left side of the display.

During diagnostic testing or manual programming of

the control, these digits will display descriptive codes

and values (as described in Entering the Manual

Mode).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

No comments

ALLIANCE HA050L User Manual Page 10