ALLIANCE HA050L User Manual download pdf (Page 15)

70381601

Entering the Manual Mode

For programming, testing, and retrieving information

from MDC, it is often necessary to enter the Manual

Mode by following the six simple steps below.

How to Enter the Manual Mode

1. Check the mode of operation for the machine.

Manual Mode cannot be accessed in End of

Cycle Mode.

2. Open the service door. The coin drawer must be

closed.

3. While pressing and holding the HIGH TEMP

keypad with one hand, press the MED TEMP

keypad with the other hand.

4. The Four-Digit Display will show “rAPd”.

Figure 6

5. Press the LOW TEMP (∧) or the DELICATES

(∨) keypad to scroll through the options until the

desired option appears in the display.

6. Press the START (enter) keypad.

There are four special features that MDC can enter

through Manual Mode. These features are:

1. Manual Programming (PrOg)

2. Manual Read Audit (AudT)

3. Diagnostic Tests (dIAg)

4. Manual Rapid Advance (rAPd)

Once in the Manual Mode, continue on into one of the

features described in detail on the following pages.

Instructions on how to exit each feature are found at

the end of each feature description.

DRY549R

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

No comments

ALLIANCE HA050L User Manual Page 15