ALLIANCE AE7133 Service Manual Page 29

  • Download
  • Add to my manuals
  • Print
  • Page
    / 125
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 28
28 60549
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
Disconnect electric power to the dryer(s) before servicing.
Close gas shut-off valve to gas dryer(s) before servicing.
Never start the dryer(s) with any guards/panels removed.
Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC DO NOT COPY or TRANSMIT
33. FRONT PANEL AND PANEL SEAL
Refer to Figure 12
a. Remove two screws from the bottom edge of
the front panel.
b. Swing the bottom of the panel away from the
dryer to disengage hold-down clips and guide
lugs from cabinet top.
c. Disconnect wires from door switch. Refer to
Figure 13.
NOTE: Refer to the appropriate wiring diagram
when rewiring the switch.
d. Remove front panel seal from flange around
inside of door opening.
NOTE: Be sure seal is properly positioned when
installing on front panel.
34. DOOR SWITCH
a. Remove two screws from the bottom edge of
the front panel. Refer to Figure 12.
b. Swing the bottom of the panel away from the
dryer to disengage hold-down clips and guide
lugs from cabinet top. Refer to Figure 12.
c. Disconnect wires from door switch. Refer to
Figure 13.
NOTE: Refer to the appropriate wiring diagram
when rewiring the switch.
d. Depress tabs on top and bottom of switch and
push out of front panel. Refer to Figure 13.
Figure 12
DRY1057P
SCREW
SCREW
LOCKNUT
DOOR
HINGE
ACCESS
DOOR
STRIKER
CATCH
GUIDE
LUG
HOLD-DOWN
CLIP
DOOR
SWITCH
FRONT
PANEL
SEAL
Figure 13
DRY1056S
DOOR
SWITCH
TABS
Page view 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 124 125

Comments to this Manuals

No comments