ALLIANCE JT37CGI Service Manual Page 51

  • Download
  • Add to my manuals
  • Print
  • Page
    / 101
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 50
M411429 53
To reduce the risk of electric shock, fire, explosion, serious injury or death:
Disconnect electric power to the tumbler before servicing.
Close gas shut-off valve to gas tumbler before servicing.
Close steam valve to steam tumbler before servicing.
Never start the tumbler with any guards/panels removed.
Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC DO NOT COPY or TRANSMIT
Section 5
Service Procedures
IMPORTANT: References made to the left or right
hand direction are taken from the operators
position facing the front of the tumbler.
54. CONTROL PANEL
Refer to Figure 1.
a. Unlock and open access panel. To hold panel
open, swing support rod under panel.
b. Manual Timer and Coin Meter Models
(1) Remove two screws holding control panel
to cabinet.
(2) Lift control panel off top edge of front
panel and pull panel forward just far
enough to disconnect wire harness at the
plug.
55. PUSH-TO-START SWITCH
a. Remove control panel.
b. Remove two screws holding switch, and
mounting bracket (if applicable), to control
panel. Refer to Figure 1.
c. Disconnect wires from switch terminals and
remove switch.
NOTE: Refer to wiring diagram when rewiring
switch.
56. COOLING, DRYING, OR RUN LIGHT
a. Remove control panel.
b. Disconnect light wire leads.
NOTE: On Coin Meter Models, the run light white
lead must be joined to the wire harness white lead
using a double spade connector. Remove the single
spade lug from the replacement run light white
wire.
c. Compress locking tabs on sides of light and
push light out through front of control panel.
Refer to Figure 2 for Coin Drop Models or
Figure 3 for Manual Timer Models.
NOTE: Refer to wiring diagram when rewiring
light.
Page view 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 100 101

Comments to this Manuals

No comments