ALLIANCE JT37CGI Service Manual Page 56

  • Download
  • Add to my manuals
  • Print
  • Page
    / 101
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 55
58 M411429
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
Disconnect electric power to the tumbler before servicing.
Close gas shut-off valve to gas tumbler before servicing.
Close steam valve to steam tumbler before servicing.
Never start the tumbler with any guards/panels removed.
Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC DO NOT COPY or TRANSMIT
62. COIN METER TIMER MOTOR
a. Remove control panel.
b. Remove two screws holding motor to mounting
bracket. Refer to Figure 6.
c. Hold cam and drive fork against inside face of
motor mounting bracket and pull motor free of
cam and drive fork.
d. Disconnect motor leads.
e. Slide cam and drive fork out from under motor
mounting bracket.
NOTE: Refer to wiring diagram when rewiring
timer motor.
63. COIN METER RUN OR HEAT SWITCH
Refer to Figure 7.
a. Remove control panel.
b. Disconnect wires from switches on timer.
c. Hold switches and actuating bracket under
switches tightly together with one hand while
removing two screws holding switches to
timing motor mounting bracket. Carefully
remove the switches and actuating bracket
parts.
d. Assemble the two switches and the two parts
making up the switch actuating bracket.
e. Actuate the switches a number of times by
manually pressing the actuating plate against
the switch lever and plunger to ensure that the
actuating parts do not bind. If binding occurs,
reposition the actuating plate slightly until the
binding stops.
NOTE: Refer to wiring diagram when rewiring
switches.
Figure 6
CAM AND
DRIVE FORK
MOTOR
MOUNTING
BRACKET
TIMER
MOTOR
SCREW
T007SE1B
Figure 7
T008SE1B
TIMER
SWITCH
ACTUATOR
BRACKET
RUN
SWITCH
HEAT
SWITCH
Page view 55
1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 100 101

Comments to this Manuals

No comments