ALLIANCE JT37CGI Service Manual download pdf (Page 90)

M411429 93

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the tumbler before servicing.

• Close gas shut-off valve to gas tumbler before servicing.

• Close steam valve to steam tumbler before servicing.

• Never start the tumbler with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the tumbler is properly grounded.

W002

WARNING

Section 6

Adjustments

114. LEVELING LEGS

NOTE: It is recommended that the front of the

tumbler be kept slightly higher than the rear

(approximately 1/8 inch, 3.0 mm). This will prevent

the clothes, while tumbling, from wearing on the

door glass gasket.

a. Check the front to rear level by rotating the

clothes cylinder until one of the cylinder ribs is

at the bottom. Place a level on the rib.

b. Check the side to side level by placing a level

on the front and rear of top panel.

c. Front leg adjustment fittings are accessed by

removing lint panel door. Rear adjustment

fittings are located on rear corner braces.

Adjust legs as needed.

NOTE: Keep the tumbler as close to the floor as

possible. All four legs must rest firmly on the floor

so weight of tumbler is evenly distributed. Tumbler

must not rock.

d. Replace lint panel.

Figure 40

T451I

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 100 101

No comments

ALLIANCE JT37CGI Service Manual Page 90