ALLIANCE JT37CGI Service Manual Page 80

  • Download
  • Add to my manuals
  • Print
  • Page
    / 101
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 79
82 M411429
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
Disconnect electric power to the tumbler before servicing.
Close gas shut-off valve to gas tumbler before servicing.
Close steam valve to steam tumbler before servicing.
Never start the tumbler with any guards/panels removed.
Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC DO NOT COPY or TRANSMIT
107. CYLINDER ASSEMBLY
a. Remove control panel.
b. Open loading door.
c. While supporting door, remove upper hinge
bolt holding door to hinge bracket.
d. Remove door from hinge bracket.
e. Unlock, open and remove lint panel. Set aside
to prevent damage.
f. Support front panel and remove screws (and
three speed nuts newer models only) holding
front panel to tumbler cabinet. Refer to
Figure 24.
g. Remove drive chain or belt.
h. Remove cylinder sprocket and key.
i. Pull cylinder out through front of cabinet.
NOTE: When removing cylinder out through front
of cabinet, spread cabinet slightly so cylinder will
clear cabinet sides.
NOTE: After reinstalling chain on cylinder, drive
and idler sprockets, adjust chain.
NOTE: After installing cylinder and shaft, adjust
cylinder.
j. Reinstall chain guard on tumbler.
Figure 31
T201PE1A
MOTOR
BRACKET
MOUNTING
BOLTS
MOTOR
MOUNTING
BOLTS
MOTOR
PULLEY
CYLINDER
MOTOR
BUSHING
BELT
TRUNNION
HOUSING
ASSEMBLY
CHAIN
SHEAVE
CYLINDER
SPROCKET
DRIVE
SPROCKET
Page view 79
1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 100 101

Comments to this Manuals

No comments